H.S.I. Dual SBN 46mm performance carb set-up.
Do you have a SuperJet or Kawi that is pretty modded but still want to get a little more out of it? Or wanting a little more cost effective carb setup for you 900-1100cc engine? We've got you covered with this bolt on ready setup!
Jetted to spec for your Yamaha 701/760cc, DASA, Xscream, TPE, or your Kawasaki 750/800cc.
This upgrade is the final touch for a Yamaha 701 or 760cc setup that is ported, piped with a lay down exhaust, has a high compression head, and/or an MSD enhancer. Also a great upgrade for the Kawasaki 750 and 800cc's if ported, piped, and you're ok with your ski sipping a little more gas than the OEM setups. Great eco-friendly carb setup with linear power for a 900 through 1100cc engine.
Reliability and added power - what's better then that?
FYI *You will need a different intake manifold than the OEM kawasaki and the Yamaha Superjet manifolds for running these dual carbs. You will also need to make sure that you have/install two pulse fittings on the engine for this carb setup.
Yamaha - You can upgrade to the DASA, PHP or any aftermarket billet 62t based intake manifold that will flow more air. OR you can utilize the OEM Yamaha 64x (44mm) intake manifold with our billet carb manifold plate to save some money. (The OEM intake manifold will need port matched)
Kawasaki - You can upgrade to the Wax Racing or any aftermarket billet Kawi based intake manifold meant for 44+mm carburetors.
The carbs include:
- Billet throttle drum
- Mikuni coupler linkage
- Billet carb bracket
- Primer fittings
- Carb base gaskets
- Flame arrestor gaskets
- 2x Plastic 1/4" tee fittings
*You can add separately standard low type or tall stack air filter adapters, and ProK performance filters or SE stainless performance filters here.
PLEASE NOTE: Include in the notes section at checkout the model of ski your engine is in, if it is a Yamaha or Kawasaki, what displacement the engine is, the elevation where you ride, what ignition you have, and if it has a stock or aftermarket exhaust. *This carb setup usually takes 4-6 business days to be fit into the service schedule for assembly - we will email you to verify prior to assembling.
** H.S.I. is not at fault if you run this carb setup on an application that the carbs were not set up for
Part Number(s): 2x 01-BN46-42-8002 + 01-53-0622 + HSI-01-0010 + HSI-01-0011K + 2x 88-2013 + 2x 88-2-2350 + 2x 90-0001